MAR 17, 1997

1996 JEEP CHEROKEE

THE WEB MOUNTED REAR SEAT BELT INBOARD ANCHOR POSITIONS MAY NOT ACHIEVE THE REQUIRED LOAD OF FMVSS NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES."

IN THE EVENT OF A CRASH, THE VEHICLE OCCUPANT WOULD NOT BE PROPERLY SECURED.

DEALERS WILL ADD A WASHER TO EACH REAR INBOARD SEAT BELT ANCHOR ATTACHMENT.

77000

CHRYSLER CORPORATION

APR 28, 1997

1996 JEEP CHEROKEE

DURING ASSEMBLY OF THE FRAME, A FILLET WELD THAT JOINS THE INNER STEERING GEAR ATTACHMENT REINFORCEMENT TO THE FRAME RAIL, WAS OMITTED.

DUE TO HIGH STEERING LOAD EVENTS, VEHICLES CAN EXHIBIT BROKEN STEERING GEAR ATTACHING BOLTS OR FRAME RAIL CRACKING AT THE STEERING GEAR ATTACHING POINT INCREASING THE RISK OF A VEHICLE CRASH.

DEALERS WILL INSPECT THE VEHICLES FOR CRACKS IN THE FRAME RAIL. VEHICLES THAT SHOW CRACKS WILL BE EQUIPPED WITH REINFORCEMENT PLATES. VEHICLES THAT ARE FOUND TO BE FREE OF CRACKS WILL HAVE A SLOT CUT IN THE CROSS MEMBER AND THE FILLET WELD WILL BE ADDED.

2500

CHRYSLER CORPORATION

OCT 11, 1995

1996 JEEP CHEROKEE

THE FASTENERS WHICH SECURE THE ALTERNATOR CIRCUIT FUSE TO THE POWER DISTRIBUTION CENTER MAY HAVE AN IMPROPER CLAMP LOAD.

IMPROPER CLAMPING CAN RESULT IN ARCING AT THE CONNECTION POTENTIALLY CAUSING A FIRE IN THE ENGINE COMPARTMENT.

DEALERS WILL REPLACE THE ALTERNATOR FUSE WITH A FUSE LINK AND ANY DAMAGE TO THE POWER DISTRIBUTION CENTER WILL BE REPAIRED.

32000

CHRYSLER CORPORATION

MAY 10, 2000

1996 JEEP CHEROKEE

VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.

THE REDUCED STRENGTH CAN ALLOW THE CAST IRON WEAR SURFACE TO SEPARATE FROM THE HUB, REDUCING THE BRAKE EFFECTIVENESS OF THE VEHICLE.

DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.

589000

DAIMLERCHRYSLER CORPORATION 879

MAR 23, 2006

1996 JEEP CHEROKEE

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

61944

PRO-A MOTORS, INC.

MAR 13, 2006

1996 JEEP CHEROKEE

CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK.

LOSS OF BRAKE FLUID CAN LEAD TO A DECREASE IN BRAKE LINE PRESSURE AND AN INCREASE IN STOPPING DISTANCE, WHICH CAN RESULT IN A VEHICLE CRASH.

AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.

7440

BRAKE PARTS, INC.